Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Blower motor of Trane XE80 furnace won't start
[ 8 Answers ]
I have a Trane XE80 gas furnace. The purge motor and burner go on, but main motor won't run. LED flashing light flashes continuously when burner is on however, when the burner shuts off, the LED light flashes 4 times at an interval. I tried to look for a reset button on the main blower motor but...
Trane XE80 ignites then goes out.repeats
[ 2 Answers ]
Hi all, I have a Trane xe 80 furnace approximatly 9 years old. When started this year, when heat is commanded. The blower starts, it clicks, ignites for about 3 seconds, and then stops. Blower comes on again, it ignites for about 3 seconds, then stops. It will repeat about 10 times this way. I...
Trane XE80
[ 1 Answers ]
My 10 year old Trane XE80 in my woodworking shop lately cannot put out enough heat to satisfy the thermostat, which yesterday was set at 72 degrees on a 37 degree day. The steel building is completely insulated, and this has never happened before at this outside temperature. The furnace seems to...
Trane XE80 Won't ignite
[ 4 Answers ]
My thermostat calls for heat, but the blower just comes on and blows air. No heat until I go down and manually restart the furnace. Any suggestions?
Trane XE80 Won't Start
[ 1 Answers ]
My thermostat calls for heat, but the blower just comes on and blows air. No heat until I go down and manually restart the furnace. Any suggestions? View more questions Search
|