Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Ruud seers 10 compressor
[ 1 Answers ]
Breaker at circuit breaker box kept tripping out as soon as I turned the breaker on. Noticed it looked like water had gotten in the unit electrical box under the cover and a burned wire on capacitor,as soon as I disconnected one of compressor wires I was able to turn the unit on but now only have...
Can I buy a new AC compressor for my 13 yr old Ruud Seer !0?
[ 1 Answers ]
I am told my compressor is nearly done, and were I to buy a new one, as of two months ago, it would be unlike the one I have, and I would have to replace lines into my house and much more, and after doing all that I would still be left with a 13 yr old furnace, so I am told I should just spend $5K...
Condensing unit fan stops compressor still runs?
[ 1 Answers ]
I have a Bryant 561C, about 7 years old. The Fan on the outside condensing unit would stop but the compressor would stay running. Tested the fan motor and it was drawing high amps. Replaced the fan motor but the unit will run for about 30 to 45 minutes. And the fan will stop but the compressor...
AC running loudly and then fan stops
[ 1 Answers ]
My central air unit was making a loud noise. The fan at the top was running and then it stopped and the noise got louder. If I let it sit for a while I can turn it back on, but it will only run for a few minutes. I turned the main power of to it, swept out from under it and in it, and even rinsed...
Ruud varible speed air handler
[ 3 Answers ]
I am installing a new two stage heat pump, rudd IUHPL. The 24 volt transformer is in the air handler. The transformer is energized and putting out 24 vt. Which enters the circuit board. The red wire leaving the board is 0 vt. As I understand the system this red wire is supposed to supply 24 vt to... View more questions Search
|