Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Trouble shooting Rheem hot water heater
[ 13 Answers ]
How do I figure out what part is wrong with my Rheem Power Vent S/N 1094 D22371: which is powered by the RobertShawcontrols. The water heater won't turn on the gas to heat it up. I think it's the Ingition Control Justiceair
Concord furnace trouble shooting
[ 4 Answers ]
My concord furnace blower works but the burner will not ignite,after a few seconds the blower shuts off.
Trouble shooting furnace
[ 3 Answers ]
Hello I have a Altra 90 SX Armstrong furnace that has a cycle problem. The model # is a GUK75D103A with a Heatcraft control board 404030001 Cat. # 70K98 The problem that I'm actually having is that it is going through its cycles OK, except the induced fan keeps running and won't shut off. ...
Furnace Trouble shooting
[ 1 Answers ]
I have an Coleman Evcon Furnace. Model #15020A the problem is I replaced the Inducer motor, and The furnace starts like normal but then the flames goes out after about a minute or two. The LED light says the Pressure switch is stuck open but it seems fine. I tried to replace the PC board but can't...
Trouble shooting GMP Furnace
[ 1 Answers ]
I have a gmp075-4 gas fired furnace, I just replaced the gas valve and the thing starts up fine but when the burner fires and the hot bar goes out the burner goes out any ideas? Limit switch maybe ? View more questions Search
|