Ask Experts Questions for FREE Help !
Ask
    thetaxidad's Avatar
    thetaxidad Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 12, 2009, 06:41 AM
    Replacing Honeywell VS8421D2003 Nat Gas valve
    I have a Pyromaster vent-free fireplace. The pilot light will light, but when I turn the gas valve to the "on" position, the pilot light shuts off. Any suggestions? The valve is a Honeywell VS8421D2003, Reg 3.5 Hi 1.7, 30 mV power unit. I have replaced nothing so far.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Nov 12, 2009, 06:22 PM
    Does this unit also have a millivolt generator near the pilot?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Converting lp gas water heater to natural gas [ 3 Answers ]

Is it possible to convert a lp gas water to a natural gas water heater or will I need to get a new heater?

Carrier furnace gas valve opens too late [ 7 Answers ]

I have a carrier weathermaker downdraft heat&ac unit that fails to open the gas valve soon enough after the ignitor is glowing before it cycles through another attempt or "locks out". With the inducer motor running and ignitor glowing good either nothing else happens or a hissing noise like a...

Model 36C03 gas valve connections [ 3 Answers ]

I need to install a White-Rodgers Universal Standing Gas Valve model 36C03 on a Colemand mobile home furnace model 7670A. The old control which was made by General Controls is absolete and had three small gas lines labeled vent, pilot, and one on top that was not labeled. I can figure out the vent...

Replacing a Honeywell T8575D2003 with a Honeywell RTH8500. Having trouble with wires [ 1 Answers ]

I'm replacing a Honeywell T8575D2003 with a Honeywell RTH8500. Didn't think there would be issues, manuals are all straight forward. However when I removed the T8575, the wiring set up did not match what the RTH8500 was expecting. The T8575 has 8 wires connected as follows < 1 ...

Replacing Honeywell T8411R with Honeywell RTH7500 - wiring problems [ 1 Answers ]

I need help getting my new, programmable thermostat to work. I currently have a dual-stage Heat Pump and A/C unit that works fine. The current thermostat is the Honeywell T8411R. I don't know the number for the subbase, but it's the one that came with the thermostat. The current (operational)...


View more questions Search