Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Noma programmable 52-2570-6
[ 5 Answers ]
Any ideas why this system (which is new to me) always goes a degree higher than what it is set for? Example: I have it set for 16.5 and it goes to 17.5 When I have it set for 17.5 it goes to 18.5 I have it on the +/- 0.3 setting Thanks for any input...
Installing a noma 5+1+1 day Programmable Thermostat and I'm over heating
[ 1 Answers ]
Greetings, I am replacing the original mercury thermo in the house we purchased about 6 months ago. After installing it to the best of my knowledge (I read the little booklet) I found that the furnace (a oil powered water heater which is pumped throughout the house) is heating up the house well...
Installed new Noma thermostat 52-2570-6 heat stays on
[ 2 Answers ]
I bought this Noma thermostat and the heat stays on, no matter what. Even if I detach the front plate the heat remains on. When I reinstall the old mercury swtiched thermostat it works fine. I have a 2 wire hydronic heat system. Can anyone tell me why the heat stays on? Any advise will help....
NOMA 52-2570-6 Programmable Thermostat.
[ 1 Answers ]
Purchased NOMA 52-2570-6 Programmable Thermostat. Page 32 of Manual says:"Install 2 AA batteries, following polarity as marked; (in the right side on the rear of unit). "LCD screen will immediately show the room temperature." (I build my own computers, so I'm not inable) LCD screen did NOT light... View more questions Search
|