Ask Experts Questions for FREE Help !
Ask
    the saab man's Avatar
    the saab man Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Sep 2, 2009, 03:42 AM
    No heat
    Can anyone tell me why a split unit Air conditioner with an Heat exchanger only pushes out cold air to the inside of a room even when set to heat?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Sep 2, 2009, 06:06 AM
    Brand and exact model number of equipment?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Unit conversion of specific heat to heat transfer coefficient (U factor) [ 1 Answers ]

I would like to know the conversion of "Specific Heat"(KJ/Kg/K) to "Overall Heat Transfer Coefficient"(W/m2/K) for the calculation of heat load. Looking forward for the answers. Immediate reply would be appreciated. Thanks, Rupesh

Carrier Hvac heat pump with aux/em heat- NO AUX HEAT [ 1 Answers ]

I have tried to install Honeywell 7500d thermostat. I get heat pump heat but no emergency heat although the termostate is calling for it. The installation manual says to see authorized agent if I have a dual 0/b on existing thermostat and another wire is attached to common. As of now, I have ...

NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue. [ 11 Answers ]

I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -

Hunter 44155C Wiring - A/C turns on during heat cycle or heat will not shut off [ 0 Answers ]

Trying this again with the correct thermostat specs. Sorry, guys! It's a Hunter 44155C and the wires I have going into it are: White - W/B Red - Rh Green - G Yellow - Y1 Jumper from Rh-Rc

View more questions Search