I have a Evcon furnace model DGAA056BDTB and the cover plate for the controls box is missing. I am told that the fault codes were on the back of the plate. Where can I get a replacement cover or at least get the fault codes for my furnace?
Add your answer here.
Check out some similar questions!
Coleman evcon furnace [ 5 Answers ]
My home has coleman evcon furnace 12 years old.I can set the thermostat at 74 degrees and the furnace will start with a 30second purge then the ignitor will warm up and glow red then the main burner lights.then the burner stays lit and the blower runs for a couple minutes. Then the thermostat calls...
Blower during furnace operation on electric Coleman Evcon [ 2 Answers ]
I just installed a programmable thermostat for an electric Coleman Evcon furnace. Now when the furnace comes on the blower also comes on. Sometimes the blower goes off a minute or so before the furnace stops. It never did this before- in fact I didn't even know there was a blower. Do I need to...
Centrifugal- Won't come on Coleman-Evcon Furnace- [ 2 Answers ]
Hi, Just found your site today-yipee! I have a problem with my Coleman-Evcon furnace (it has had A/C added)-just bought the house this year, but previous occupants said all was working before. When I turn on the heat on the thermostat, I get a code 3 readout, "Centrifugal Swithch Open"; I had...
Coleman, Evcon Ignition Failure [ 1 Answers ]
A couple of years ago, there was a recall on a part that a Company had to come out and replace. I had never had a problem with the furnace for 8 years. A short time later, I started having problems with ignition failure. I had a part replaced and a licensed Company went over everything and said...
Coleman evcon [ 2 Answers ]
Fan won't come on in heat position
View more questions Search