Ask Experts Questions for FREE Help !
Ask
    shah123's Avatar
    shah123 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 18, 2009, 08:05 PM
    Motor fins for trane XE 80 furnace are bent and makes loud noise.Any idea to stop it?
    Motor fins for the Trane XE 80 furnace seems be bent. It hits the case which is making loud noise. Sometimes the furnace won't start and make humming noise. It seems like motor gets jammed and won't turn. Any idea how to solve this issue?
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #2

    Dec 18, 2009, 08:52 PM
    Replace the damaged wheel before it starts ejecting vanes and causing further damage to the furnace.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gas Trane Furnace makes loud clunking noise when goes on and off [ 6 Answers ]

I have a gas Trane furnace, new in 2004, it has started making a loud clunking noise when it starts up and when the cycle ends. What is this noise, and how do I remedy it? I have a new filter that I can put in. Thank You. Sheri Tavens

Dryer makes a loud clunking noise [ 3 Answers ]

My ten year old but limited use Frigidaire dryer has a high squeal pitch as well as a loud clunking sound when in use. Can this all be fix by replacing the rear bearings?

My kitchen sink makes loud noise when on. [ 1 Answers ]

I HAVE THE SAME PROBLEM. WHAT TO DO???? #1 Mar 25, 2007, 10:08 AM Aquavelvet New Member Join Date: Mar 2007 Posts: 1

Heater makes a loud generator noise [ 8 Answers ]

When I turn on my heater it makes a loud noise (sounds like a running generator). The a/c runs fine.

GE Washer makes loud noise [ 3 Answers ]

I have an older GE washer (about 5-7 years old) that has started making a loud, dry metallic grinding sound when running. I had to replace the clutch about 4 years ago and recently the clip that holds it in place came loose and I had to snap it back in place. The washer worked fine for a few...

View more questions Search