 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Magic chef furnace models
I have a Magic Chef LP gas furnace (Model EG6E100DC-1). Last week the heat wasn't kicking on in the morning and found that the draft inducer blower had cooked a bearing. I shut down power to the unit, removed the blower, sourced a new blower, installed exactly as I had removed it. The draft inducer ran like a charm, the igniter fired the pilot w/ a strong flame and after a few seconds the burner fully ignited. It stayed lit for probably 45 seconds (just prior to the normal time that the main blower would turn on in this unit) then went out. I turned the power switch back off (since the draft blower was still running) and then back on. The entire process above repeated, but the full burner burn only lasted ~20 seconds. Now burner doesn't fire at all. I can hear the relay clicking on when the switch is flipped, the wall thermostat is high enough to light, the DIB is running the whole time. The pilot has a strong flame. Any thoughts of what to check next? Any way to check gas valve?
|
||||
Check out some similar questions!
I have an old Magic Chef gas furnace in my garage. Gas is connected, but wiring for fan and thermostat are a question. 55K BTU, 12 amp blower. Need to know what wires to connect to thermostat. Also, there are three wires exiting furnace. I know which ones power the 110v blower, but there is a...
The main burner of my Magic Chef Ultra II furnace will not light normally. The furnace has an electronic ignition. Its blower, electronic igniter and pilot burner seem to be functioning normally, but the main burner won't fire up unless I blow on the pilot flame several times. When I do blow on the...
I have an Ultra 97 gas fired heater made by Magic Chef. I assume its about 15-18 years old. When the heater kicks on, the only thing that happens is that the blower starts running but the ignitor does not ignite. There are 2 flat cylinder type switches when you open up the door. If you tap on...
Approximately 20 seconds after the system commands heat we hear a loud thumping Noise coming from the 2" plastic vent inside the wall next to our bedroom. It lasts for Approximately 45 seconds with 5 second intervals. The furnace is about 20 yrs old and Works fine otherwise. It started last...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
