Lincoln 20KW Electric Furnace

hvac1000 · Dec 3, 2008, 03:24 AM

Good luck finding one. Lincoln furnace was a small manufacturer that was more of assembly point. They made the cabinets BUT all the components that went into the furnace were off the shelf. All parts for there furnaces are available but you will just need the original part number off the parts to get them Or know enough about electric furnaces to know what to use in the original parts place.

Lincon put a wiring diagram on the back side of the blower door access panel and the clerance to combustibles is listed on the model number tag as required by law.

Sorry but that is all I know about Lincoln.

terreneuve · Dec 3, 2008, 03:52 AM

For thermostat control would you think the low voltage side terminal block would be wired to the thermostat as other electric furnaces as no control side wiring diagram with the furnace.

Are Lincoln now out of business as this was manufactured in 2005?

Thanks brother!

John

hvac1000 · Dec 3, 2008, 04:40 AM

First look on the model number label and post the address and state along with the exact model number where lincoln is now located. By law it is required to be there with the model number.

The low voltage for heat only should be the R=Red and W=white terminals on the low volt wiring strip. If blower control terminal is available it will be the G=green terminal.

terreneuve · Dec 3, 2008, 06:44 AM

There is no address just "Made in Canada" The model number is FEM20-M2401AM-A.
Power is 20KW

Thanks
John

hvac1000 · Dec 3, 2008, 11:00 AM

Sorry no help here. I have looked through all my electronic model ID's.

Lincoln 20KW Electric Furnace

Add your answer here.

Check out some similar questions!