Ask Experts Questions for FREE Help !
Ask
    awlocls's Avatar
    awlocls Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 28, 2007, 10:24 AM
    LED code PF for Carrier 8000TS
    Heater Blower will not start. Code on led is PF.
    How do I correct and or repair?
    Thanks.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Dec 28, 2007, 11:07 AM
    If you have a ECM motor in that furnace you better call a Carrier dealer for repair. That is a very expensive two piece motor. The main motor,a electronic bell housing and a board for selecting blower speeds.

    If this furnace gets played with by people who do not have the knowledge to work on it you will spend a small fortune for parts if they short out.

    This is the only information I have for that unit. Sorry I cannot help you.
    Note you might the door on the furnace listing the trouble codes.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Code 54 on carrier weathermaker furnace [ 1 Answers ]

My furnace stopped working today. It is a weathermaker (carrier) 8000 That is approx 14 years old. It has been serviced regularly To the best I can tell it is flashing a code 5 4 can anyone help me with this? It kicks on, blows cold air for a few minutes then shuts down. Thank you

Carrier Weathermaker 8000 Trouble Code [ 2 Answers ]

I have a carrier Weathermaker 8000. Started up furnace and forgot to remove baffle. Now have trouble code 33 and have to manually reset. How do I accomplish this?

Carrier 2 Stage Gas Furnace Code 33 [ 1 Answers ]

We are having trouble last couple of days now that temp is near 0. The thermostat is calling for heat the furnace runs as follows. It runs on low stage for about 16 minutes and then the high stage turns on for a couple of minutes. The burner then shuts off and the blower shuts off and there is...

Carrier Ignition Lockout Code & Ignitor Problem [ 3 Answers ]

The code I'm getting is 14 for ignition lockout, will reset in 3 hrs. The furnace tries to ignite 3 or 4 times and then the code trips and shuts the furnace down. I usually just flip the manual switch to get it going again but if I'm not home to pay attention or if we're asleep the house will...

Carrier Diagostic Code [ 1 Answers ]

Does anyone know what the problem is with my Carrier heating unit if the red light remains steady followed by 2 fast flashes? Thanks!


View more questions Search