Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
My furnace fault code light flashes three times the pause and flashes three times aga
[ 3 Answers ]
My furnace fault code light flashes three times the pause and flashes three times again and repeats. What is wrong?
Bryant furnace fan cycles on 1 or 2 times for 2 or 3 sec. After heat cycle has ended
[ 8 Answers ]
I have a Bryant furnace Mod. #394GAD024050 and after the temp has reached the set point and the furnace has cycled off the fan will come back on a couple of times for approx. 2 or 3 seconds. In the older furnaces with a machanical fan/limit switch some times the temp would creep up and cause the...
Carrier furnace purge exhaust fan continues to cycle and cycle
[ 3 Answers ]
Carrier furnace/AC Product model #58ZAV 075-101JC Model #58ZAV 075-JC Series 100 Serial #2093A16 303 Natural Gas/Propane, heat furnace runs on Propane. Problem: With the unit turned to cooling with the thermostat, the heat pre-purge exhaust fan continues to cycle on and off, sometimes...
Steam boiler cycle times
[ 2 Answers ]
I just had a Peerless WBV-03 SPL steam boiler installed. At the start, the burner shuts off once it reaches 1.75 PSI, about 20-25 minutes. From there on it runs for about 2 minutes, shuts down at 1.75 PSI and restarts in two minutes when there is no pressure reading on the gauge. This continues...
Grandfathers clock dongs one to many times on the hour
[ 1 Answers ]
Can any one give me advice on how to fix my grandfathers clock. When it is two o'clock it dongs three times when, when its three o'clock it dongs four times and so on. My husband thinks that maybe he wound the hands forward when setting the time instead of counter clockwise. View more questions Search
|