Ask Experts Questions for FREE Help !
Ask
    daveee's Avatar
    daveee Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 16, 2009, 06:48 PM
    How do I set my psi on my boiler
    My boiler heats up to 180 but I have no psi according to the gauge
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Dec 16, 2009, 06:53 PM
    Gauge could be defective. If not the altitude or as some call it pressure is caused and controlled by the cold water feed line that is attached to the boiler. Usually there is an automatic feed valve that is preset for your system so it does not over fill and cause too much pressure. Now the fill valve could also be bad so you will have to check things out before just adding water.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hunter thermostat not reaching set temperature [ 2 Answers ]

My hunter thermostat model 47110A is set to 20 degrees celsius but the furnace will not stay on long enough for the temperature to rise to the set degree. It is currently holding at 16 degrees instead. The batteries are brand new but still the temperature will not rise. This is my first home so...

Set slope on sub slab plumbing [ 0 Answers ]

I'm getting ready to cut up my basement slab for a bathroom. I've got the pipes laid out and vented for shower, toilet, and sink and re-route of the kitchen drain above. I'll be trenching about 10 feet to reach main drain. Any hints on setting the slope for this run and all the 2 inch going in it?...

Burnham Boiler not reaching Thermostat set point [ 1 Answers ]

I have a Burnham series 2a gas boiler. This morning we woke up to a temperature of 66 degrees. The set point for the honeywell thermostat is 72 degrees. Since I have been home, the boiler will kick on and shut off when the temp reaches 67. I have increased the set point to 78 degrees and yet it...

How to set up thermor bw971 bios home weather station [ 0 Answers ]

I have a thermor bios home weather station for TV only. No usb hook up for computer. I lost my instruction manual and I need to find out how to make it communicate with the transmitter. When I connect everything, it displays on the TV and gives the indoor temp, barometric pressure and humidity but...


View more questions Search