Ask Experts Questions for FREE Help !
Ask
    flutie711's Avatar
    flutie711 Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 28, 2010, 04:26 PM
    Have a Trane xl90 furnace that I replaced the blower motor and capacitor ,
    , now blower won't shut off. Any ideas?"

Check out some similar questions!

Blower motor of Trane XE80 furnace won't start [ 8 Answers ]

I have a Trane XE80 gas furnace. The purge motor and burner go on, but main motor won't run. LED flashing light flashes continuously when burner is on however, when the burner shuts off, the LED light flashes 4 times at an interval. I tried to look for a reset button on the main blower motor but...

Trane xl90 blower motor inop [ 0 Answers ]

I have a Trane XL90 furnace. The blower motor just hums when I turn it on heat or cool. I pulled the blower motor and housing out of the furnace and it works fine sitting on the basement floor but when I reinstall it into the furnace, it just goes back to humming. Any help would be greatly...

A/C mode, Lenox furnace blower does not come on. New Capacitor and Motor. Still broke [ 1 Answers ]

In A/C mode, blower motor will not come on. I replaced motor and capacitor but it still does not come on. Will not run with thermostat in RUN mode either.

How does one test the capacitor or Verify a bad furnace blower motor? [ 3 Answers ]

Carrier product 58pAV090 model # 58PAVO90-14 Series 161. Main blower needed cleaning bad and I did so. Now it appears that it won't cycle back on .At times the motor runs perfectly from start to finish and at both the cool and the heat cycling times.But not both. If I tape the switch and help the...

Trane xl90 gas furnace red light [ 1 Answers ]

I have trane xl90 gas upflow furnace red light blinking on circuit board no legend any where anybody know where to get information


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.