Check out some similar questions!
Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset
[ 5 Answers ]
I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...
Goodman GMN080-4 won't light! It's cold out
[ 7 Answers ]
I have Goodman gmn080-4 furnace. It won't light the ignitor, and has 3 flashing red lights which I was told was the vacuum switch, which I tested by blowing on it to verify it opens and closes. Here is the sequence.. 1. start the furnace.. 2. Transducer kicks on and runs for about 10...
Goodman furnace
[ 1 Answers ]
Furnace flame will stay on for 5 seconds and shut off. Led light on circuit board flashes once after it completes cycle. 1 flash indicates the following possible problems: Gas flow... Gas pressure... flame sensor... as a result, everything seems to be working normal. However, I did replace the...
Goodman furnace
[ 5 Answers ]
The furnace comes on and the furnace ignites. It then burns for a few seconds and goes off without the fan coming on. I have changed the flame sensor. Didn't help. Also the fan will come on by itself without the furnace coming on. Help!!
Goodman furnace
[ 17 Answers ]
I have a goodman furnace. Forced air. No a/c. I turn the power on and she starts. Thermostat is off. No wires are crossed that are visible. The pilot does not ignite but the heating element is on. No gas seems to be coming through. Any suggestions? The furnace is only a year and a half old. View more questions Search
Add your answer here.
|