Goodman Furnace Model GMPN060-3 Three Blinks Diagnostics.
I have a Goodman Furnace Model GMPN060-3. I get three blinks biagnostic code. I changed venter (motor assembly) and pressure switch. Still the same three blinks. Moisture drain path is clean and free of debries. After the new parts, furnace started once, but would not start again -- same three blinks. Reset all power switches and waited overnight for things to reset, but still will not start i.e. three blinks. Blower fan is OK, runs on manual. Replaced new filter.
When the problem first started the problem was intermitent. Furnace would start only in the morning when everything was cold. When it had gone through one cycle it would not start again but give the three blinks. So I changed the pressure switch (1.19", part B13701-48) and the venter assembly (Fasco 7021-9087) based on inside panel diagnostic guidance.
Check the square multi-connector at the main circuit board-unplug and reconnect it a few times to "scrub off" the pins and sockets. I hate to say it, but the circuit board on these units is a real egg-vulnerable to oxidation and premature failure. Also check the exhaust vent for sags and/or trapped water.
Thanks for the guidance from this forum. I checked the venting and found blockage due to bee hive (yellow jackets???) nest remnants. The furnace pipes exhaust in the back yard where we have a bee problem. Thanks for your feed back and suggestions. It avoided me a costly call from the repair person.
Check the square multi-connector at the main circuit board-unplug and reconnect it a few times to "scrub off" the pins and sockets. I hate to say it, but the circuit board on these units is a real egg-vulnerable to oxidation and premature failure. Also check the exhaust vent for sags and/or trapped water.
It avoided me a costly call from the repair person.
It may have saved you a service call but you more than likely changed out parts that didn't need to be changed. The money you wasted randomly changing out parts probably would have covered a service tech finding your problem and solving it, the difference is that the route you took just took longer.
I wonder why the yellow jackets picked on a janitrol furnace,,,some would say it was the faught of the furnace,,,,could have happened to any brand but since goodman is second largest un-advertized heating and a/c company in the world,,they have more equipment in more homes,,so I guess the percentages of something going wrong would be high also,,,,,,,,more red apples than yellow apples,,,so more red apples to get chewed on
Linear Mode
