Ask Experts Questions for FREE Help !
Ask
    cliff1105's Avatar
    cliff1105 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 5, 2009, 10:43 AM
    Gmp075-3 ignites then shuts down
    I have a gmp075-3 installed 2000 I have noticed this summer the blower will come on by itself even when turn off at thermostate didn't think nothing of it thought it was just hot up in the attic but now that it is cooled off when I went to turn the heat on the burner ingnite all three then 10 to 15 sec they shut down it will do this 3 times the on the circuit board it flashes 1 times slowly over and over I clean the flame sensor still doeing the same thing.I also ruled out the thermostate any help would greatly be appreciated. Thank you for your time
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 5, 2009, 01:49 PM
    Usually the flame sensor causes this problem OR a grounding problem with the sensor or some other component. Take your meter and get a reading on the flame sensor so we know what it is putting out.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace ignites then shuts down [ 3 Answers ]

When my Goodman furnace (CWP#00299785) turns on, the blower works and the burners ignite, but after a few seconds the burners extinguish. Then the burners ignite again for a few seconds and extinguish once again. Please tell me what part(s) I need and where those parts are located on the furnace....

Day&night furnace ignites burner then shuts off [ 3 Answers ]

Hi, I am trying to determine which part to replace on my 1989 day and night furnace. The furnace igniter lights the pilot when the t-stat calls for heat (I bypassed the t-stat to make sure the problem was not with the tstat by putting a jumper between the red and white to call for heat)....

Furnace ignites but blower won't start till furnace shuts down. [ 7 Answers ]

(Nordyne/Miller G3RA)-I have a furnace HSI(glow plug) that will ignite and burn until it gets too hot and shuts down. As soon as the furnace shuts down the blower starts to circulate air. The blower circulating air cools the furnace and it reignites.Shortly after the furnace ignites the blower...

Gas furnace ignites intermittently-ignites after removing cover from ignitor chamber [ 3 Answers ]

Unit: Carrier WeatherMaker 9200 gas furnace, with an HSI ignitor Symptom 1: Thermostat is calling for heat, as evidenced by a flame icon on thermostat face, but no action in the furnace. Symptom 2: Ignites only AFTER I initiate Action 2 below. Then it seems to work for a while, until the...

View more questions Search