Add your answer here.
Check out some similar questions!
Gas furnace Outside Fixture [ 5 Answers ]
I'm wondering what options I have for outside supply and discharge? The appliance is a high efficiency York NG furnace (small, less than 60K btu.). The installation manual shows what could just be PVC elbows. I'm wondering if there are other options. The furnace is intended as backup...
York gas furnace problem [ 2 Answers ]
My furnace has a intermmitent problem. When it quits the fault code is open limit. They all are closed. I can get it to work by moving the wires at the control board connector. The connections appear to be ok. I looked at the rear of the board and did not see any bad solder joints or cracks....
Thermocouple on Old Carrier Gas furnace [ 5 Answers ]
If the thermocouple is defective, could you light the pilot and it and the burner would stay lit? How do you know it is defective? Would the defect be visible? If so, could you tell me What it would look like? The heater is 20+ years old. I have never had ONE problem with it, until I had it...
Gas furnace runs two cycles [ 1 Answers ]
My gas furnace is approx. 30 years old. The furnace will run one cycle, shut off and approx. 15 seconds later run again for a shorter period. Everything is working properly, heating correctly etc. But runs two cycles. Any thoughts on why?
View more Heating & Air Conditioning questions Search