Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Furnace not stay lit
[ 6 Answers ]
I have a Rheem Criterion II. My furnace just recently started light and then immediately have the flame go out. It doesn't do it all the time, maybe 5-6 times then the thermostat sends a signal to the furnace. I have to turn off the thermostat so that it can cycle through until it stays lit. ...
My furnace will not stay lit
[ 4 Answers ]
I have a Trane XL80 furnace. I have manually started the furnace and at the time the burners will light and continue to fire for about 5 minutes then they act like they are being blown out. The LED light at the time of start up begins to blink 4 fast blinks. The blower continues to blow cold air...
Furnace will not stay lit
[ 4 Answers ]
I have a Ruud 50,000 BTU furnace and the furnace lights but the flame goes out about ten seconds after burners kick on. The yellow light never lights up during entire process. The green light is always on and does not blink. I cleaned the flame sensor with fine sandpaper and re-installed after...
Gas Furnace will not stay lit
[ 3 Answers ]
I have a furnace that's about 30 yrs old. The pilot stays lit and it kicks on for about 30 seconds and then blows out along with the pilot light. We have vacuumed out the flue and the whole furnace with no results
GE Furnace won't stay lit
[ 4 Answers ]
We've got an old (25y.o.) GE mod #BLD106F furnace, and it refuses to stay lit. The igniter will ignite the gas, then as soon as the spark goes out, the gas shuts down. Ends up sounding like woof woof woof. We replaced the Pilot Detector to no avail. To make matters more confusing, it will lite... View more questions Search
|