Ask Experts Questions for FREE Help !
Ask
    dbobst's Avatar
    dbobst Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 29, 2007, 08:56 PM
    My furnace will not kick on!
    My furnace will work regulary sometimes, but sometime it does not kick on by itself you have to turn the thermostat to off then back on and then it will run until it meets the tempature setting. But then when its time for it to kick back on it does the same thing. We have replaced the thermostat 3 times. We ran a new wire from the thermostat to the furnace we've replace the control panel or board. Nothing seems to work! Any answers
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
    		  
    #2

    Jan 29, 2007, 09:27 PM
    Sounds like the furnace is locking out, when you turn the thermostat off and on it just resets the PC board.
    https://www.askmehelpdesk.com/heatin...tml#post268203
    Gas forced air/Where is the diagnostic light?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman Furnace won't kick in [ 5 Answers ]

Hi have been reading the various posts for a couple hours now. When my Goodman GMNT-080-48 forced air starts up, all appears well on start up sequence ; blower runs and igniter heats up and then turns off. Blower never comes on and the heat never seems to get going full. The little red light...

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

Furnace won't kick on [ 1 Answers ]

My pilot light is lit on my furnace but the furnace won't kick on. I changed the thermostat and it did fire up but after running a short while it started to blow only cold air. Can anyone tell me what could possibly be wrong?

My Furnace won't kick on even after I've manually primed it 10 times [ 1 Answers ]

I need to know why I can't seem to keep the furnace running I prime it it stays on for 2 minutes then shuts down even before the blower starts . What's up with the red light near the reset button

A/c compressor won't kick in [ 4 Answers ]

I have a window a/c unit with a compressor that won't kick in. I took the unit apart and noticed the control wire on the compressor looked burnt and corroded. I took the wire off and put a new connector on, but still no go. I noticed however when I left the control wire disconnected I could hear...

View more questions Search