Furnace fan will not cut off

I have two wires connected to my furnace thermostat. There is a place labeled G on the thermostat. Can I simply run a wire from the G terminal on my thermostat to the terminal labeled G on my furnace fan relay to operate the fan separately?

Hello i have a 96 Honda Accord and the fan won't cut off. Hondas are not my speciality so and the only thing i can think of is to disconnect the fan but then the car will run hot so if someone can start me off with the trouble shuting.

How do I wire my inline duct fan to my Goodman model gmp100-4 gas furnace fan so that the inline duct fan comes on and off when the furnace fan does? I understand that I need a relay from the inline duct fan but don't know where to connect the relay to the furnace.

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...

A/C compressor on heat pump works fine, but occassionally it runs and the airhandler fan does not cut on, causing outside unit to freeze. If I turn thermo switch off and back on, it usually corrects the problem and it works fine until it fails to cut on again, maybe 5 minutes, or maybe a week. If...