Check out some similar questions!
Gas burner won't ignite [ 0 Answers ]
System is calling for heat. The draft inducer comes on, the hot surface ignitor gets red but burner won't light. I ohmed out the gas valve and it is good. I cleaned the flame sensor with soft sand paper.the IFC has a constant light on the board. What could b the problem?
Furnace burner won't ignite [ 0 Answers ]
The plate in my furnace won't Light up only the pilot light is on
Evcon furnace won't ignite [ 1 Answers ]
Our Evcon furnace is a 1995 model DGAT070BDC. It has worked great every year until last year 2011. What it did last year was ,it would ignite the ignigter but after it would glow for a minute it would call for gas and then shut down without fireing. I found the valve was bad and it worked ok after...
Rheem Criterion II burner does not ignite [ 3 Answers ]
My Rheem Criterion II Heater does not ignite (no fire), even though the whole fan system keeps working. What's wrong? It happened two years ago. A contractor replaced an ignitor. Then it backed to work. Now, it happens again. Is it the same problem? Can I replace the ignitor myself? Where can I...
View more Heating & Air Conditioning questions Search