Ask Experts Questions for FREE Help !
Ask
    sadfurnace's Avatar
    sadfurnace Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 24, 2008, 12:34 PM
    Comfortmaker furnace
    Our furnace has been working fine, but now all of a sudden only one of the three burners will ignite. This does not happen all the time, What could be the problem
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jan 24, 2008, 06:32 PM
    Call for service needs to be cleaned and serviced.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Comfortmaker Furnace Help [ 4 Answers ]

My Comfortmaker Furance (GUG070A012N) will not always kick-in at the set temp level. The Thermostat is verified operational and good. Most times the heat will kick in, but the fan blower will not run. If I remove the panel and spin the fan manually, sometimes this will engage the fan and the...

Comfortmaker gas furnace will not ignite. [ 3 Answers ]

My furnace was working yesterday and we did not turn it off, but it will not function today. I know there is electrical power at the unit; that there is gas supply; the filter is new; the inducer motor comes on when the thermostat is adjusted;but no flame appears. The inducer motor will remain...

Comfortmaker Furnace [ 2 Answers ]

I recently purchased a new Comfortmaker Furnace, the problems is it runs for approx. 4-1/2 minutes, shuts off and then comes back on in 2 minutes. I have had a couple of people check and they said that nothing is wrong with it. Any suggestions on what the problem might be?

Comfortmaker furnace shuts down [ 1 Answers ]

I have a comfortmaker furnace that is vented with a 3" duct and a blower. Recently it started where the furnace will run through it's course , the glow plug will work, then the gas valve opens and you can see the heat in the exchange and then after a few minutes the blower will come on and heat...

Comfortmaker Furnace Fan blows in line fuse and will not allow furnace to work [ 1 Answers ]

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...


View more questions Search