Ask Experts Questions for FREE Help !
Ask
    garybeasley's Avatar
    garybeasley Posts: 0, Reputation: 1
    New Member
    		  
    #1

    Jan 9, 2011, 02:03 PM
    Coleman evcon furnace troubleshooting freezing inside coils
    Coleman Evcon model number EB15B will only run on "Emergency" heat mode. Compressor froze over and coils are freezing.
    kmuh22's Avatar
    kmuh22 Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Aug 8, 2012, 09:18 PM
    I had that problem about a month ago. I had to turn off and used a hair dryer to melt the ice off the coils. Finally I found out that it was my air filter all along that needed to be changed. It worked for me hope it works for you.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman evcon furnace model no. DGU10014UB troubleshooting [ 11 Answers ]

Coleman furnace referenced in subject line ignites, getting gas, blower starts, runs for a couple minutes, unit shuts down, red LED light on board blinks ten times. Anyone know the code for this repair? I'm FREEZING! :(

Coleman evcon furnace [ 0 Answers ]

I have a coleman evcon furnace model BGD07512AX, that I have replaced the TSTAT but the main burners will not stay lit when the unit calls for heat?

Coleman evcon troubleshooting? [ 1 Answers ]

I have the coleman evcon electric furnace -- the blower works -- but doesn't put out much heat -- rather warm not hot - the unit may be in need of cleaning not sure -- or is there a part that may need replaced.

Coleman evcon furnace [ 1 Answers ]

I have a Coleman Evcon heating and air conditioning unit, model # DGAT070BDD, year 1996, in my double-wide trailer home. It is making an odd beeping noise, something like an alarm. I can't seem to find a manual to help me diagnose the problem. Any thoughts to help me?

Coleman Evcon Furnace [ 1 Answers ]

We have a Coleman Evcon DLAS075BDD furnace which keeps displaying error codes: 1-Ignition Failure and 4-Limit cycling. We have replaced the circuit board. Inspected the ignitor and the flame sensor and both appear good. Also have taken the exhaust vent/hood off and vaccuumed out any rust to...

View more questions Search