Ask Experts Questions for FREE Help !
Ask
    bcerickson's Avatar
    bcerickson Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 11, 2011, 07:21 PM
    Burners ignite and stay on, blower does not?
    I have a Rheem RRPLB024JK08E outdoor gaspack, 5 months. Old. It locked itself out, red lights indicate high limit open. Put in new high limit switch, no change. After I reset it (kill power) it works fine for about 8 or 10 cycles. Then, draft inducer comes on... burners ignite and stay on, but no blower. It will continue to lock out if I don't reset it. The guys who installed it found nothing, but of course, it worked fine when they were here.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Feb 11, 2011, 07:28 PM
    Sounds like the logic in the blower control board is bad.
    Theaircoguy's Avatar
    Theaircoguy Posts: 36, Reputation: 0
    Junior Member
    		  
    #3

    Feb 11, 2011, 07:57 PM
    I agree, it's very likely the ignition control board. If you want a second possibility it might also be something as silly as a loose connector or wire to the blower motor.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane XE80 furnace. Blower stays on. Burners ignite, then turn off. This is continuou [ 11 Answers ]

I have a Trane xe80 furnace. Last night I noticed the blower wasn't shutting off. I reset the thermostat. The blower stays on and the burners ignite for 2 seconds and turn off. This repeats over and over. Can anyone help with this, as it is very cold in Missouri right now. Also the red light...

Burners ignite, blower does not come on [ 1 Answers ]

Furnace won't stay lit.pilot light is on but burners will ignite but don't stay lit [ 1 Answers ]

Trane furnace blower doesn't come on, compressor on heat burners ignite, new stat [ 6 Answers ]

Blower won't run, even in on mode, replaced stat, still nothing, has power to motor, can turn cage freely, furnace led light says system normal, compressor for air comes on, heat ignites, just no fan blower, any ideas

Heil 7000 furnace, blower stays on and burners don't ignite [ 14 Answers ]

Furnace Info: -Upflow Condensing Gas Furnace is a Heil 7000 (model# NUGK075DG09) -Electric spark or host surface ignitor ( I think it's spark) -Installed Oct. '96 (when we built the house) -90% efficiency -wall thermostat is honeywell programmable. Don't know model but was also purchased in...

View more questions Search