Ask Experts Questions for FREE Help !
Ask
    billyj7175's Avatar
    billyj7175 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 28, 2011, 07:36 AM
    Bryant Plus 90 continuous flashing LED after self-test
    The inducer motor will run for approximately 10 seconds then shut off. I can hear a relay click at the time of shutdown. I ran the self test (momentarily shorted the Test and SW24 points) and now get a continuously flashing LED, which is "115v polarity reversed or twinning problem".

Check out some similar questions!

Bryant 310 furnace flashing LED error code. [ 1 Answers ]

My Bryant 310 furnace is flashing error code. 3 quick flashes, 3 long flashes. What does this mean?

NORDYNE G4 624631-B Relaced, continuous led, now we have heat [ 0 Answers ]

NORDYNE G4 624631-B Relaced but give continuous light. We had 5 lights but after reversing the jumpers it fixed that. Demand was set on thermostat when replaced board but didn'tknow therm was shut off and the house was locked up. Like a dummy I hit the wrong jumper. He finally came home, put on...

Flashing red LED and no heat? [ 0 Answers ]

How to turn continuous fan off on a bryant 330 gas hvac [ 0 Answers ]

Blower runs continuous, Status led flashes 5 times, false flame detected [ 6 Answers ]

I have a Goodman GPM075-4, the blower stays on all the time. The status led flashes 5 times, TS guide inside panel says "false flame detected", "stuck gas valve". Is there a way to bypass or verify this state?

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.