 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant furnace problems?
Hello,
Background: We have a bryant 90 furnace which is new since 2007. Two years ago we had to replace the Honeywell zone control model HZ311, Furnace control module model using ICM282, and what I believe is a gas control valve. 24v with numbers 36E24 210 #EF32CW201. They were replaced due to what was believe to be a power surge or lightning strike. Last year the purge sensor failed. The technician indicated this was not a very quality sensor and bypassed the switch as he indicated that if they put in a new one it would fail within a few years as well. Problem: In the last couple of weeks the heating system has failed to ignite/turn on. This is noticed when the home temperature is getting cold. The zone controller shows system on but it is not. I recycle the main electrical circuit breaker for the furnace off for 30 secs and back on. Approx 1-2 min later they furnace reboots and works normaly. This has happened three times since November. The furnace system is controlled by a three zone thermostat system. Do you have any recommendations? Thanks for your help, Tom |
||||
Check out some similar questions!
I have a 1982 Bryant 397HAW360100 model furnace. It has been acting funny and seems to be getting continually worse. It does run and does heat, but the issues I'm having is that the burners continually kick on and off. Generally now, the burners fire for about 2 seconds then shut off about 2-3...
Furnace is 5 yrs old, have reset it , thermostat goes blank, blower continues to blow but only cold air. When try to restart it, it may run for 5 minutes, then goes off and blows cold air again. Replaced fuse, shut off circuit breaker and restarted, but continues to not run. Filter is clean, no...
I have a Bryant Plus 90t Furnace installed in 2007 and the Flame Sensor keeps getting corroded it had to be cleaned three times since installed in 2007 I have no heat until it is cleaned. My question is why does it keep getting corroded. Thank You Nick [email protected]
I have a Bryant gas furnace Model Plus 90i 355MAV. When it runs in high heat mode for several minutes it makes this thumping sound that seems to be coming from the blower area, after a couple of seconds the furnace shuts down. Any Help? Unit is about 6 years old
Hello everyone, I have a Bryant 80v furnace. Everything works fine till it is time for the blower fan to come on. I have opened it up, and the fan wheel turns freely. Checked the fuse on the circuit board no problems there. I been doing some reading about it all day long. The furance lights and...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
