Ask Experts Questions for FREE Help !
Ask
    tishalynne's Avatar
    tishalynne Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 14, 2009, 03:24 AM
    Bryant 395CAV Furnace
    I have done all the usual start up procedures and nothing happened. I waited and redid the procedure again and still nothing happens. I replaced the batteries in the thermostat hoping that is all that is needed. I checked the electrical box to make sure it wasn't tripped all are on. I noticed that I don't smell any gas, shouldn't I smell a little when it is prepped and ready to ignite? The led light is on, doesn't that indicate that it is getting the 24volts? :confused:

Check out some similar questions!

Bryant 395cav error code 31 [ 9 Answers ]

I have a Bryant CAV395024070 furnace that's taking a code 31. When I run a component test, the inducer motor comes on, sometimes for only a second, sometimes for the proper amount of time, sometimes not at all. The remainder of the components all go through the test no matter what the inducer motor...

Bryant 395cav error code 24 [ 1 Answers ]

I have a bryant 395cav042091 +80. Got a new puppy that chewed up the thermostat lead to the cenral air unit outside. I repaired the wires leading to the central air but the furnace is flashing a code 24 (secondary voltage fuse is open) and nothing works. Tried Disconnecting thermostat leads and...

Bryant 395CAV blower speeds [ 1 Answers ]

Hello, It appears that my furnace (Bryant 395CAV) isn't blowing cool air at a high enough speed. I don't feel that the house is as cool as it should be - the air coming from the vents is cold, although it doesn't seem to circulate around as much as it could. I've done some "balancing" and...

How to run fan only to circulate the air Bryant 395CAV [ 1 Answers ]

Hi, I am new to this forum and beginner in heating system. I would like to know if there is a way to rewired or jumped wires to make the fan run only (without heat) to circulate the air fom the basement. My furnace is a Bryant model 395 CAV Series G, thermostat is only 2 wires. If I have not...

Bryant 395CAV Furnace Won't Start [ 3 Answers ]

The furnace typically takes three or four ignition cycles before flame extends down burner to reach the flame sensor. It seems to light only halfway down burner on most attempts. Sometimes reaches shut off and then I have to flick switch to repeat cycle. Help.


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.