Hi, I am installing two baseboard heaters in an additionn (two separate rooms). I will be running new wire and putting them on the same circuit. The heaters will be 48" 240V rated at 1000 Watts (4.2 amps). My qestions: -What size wire should I use (12/3, 10/3, etc.)? -What should the amp...

I have to replace a missing baseboard heater 110 volt 1500 watt all I can find at home depot Lowe's etc is 220 volt can I use one of those hooked to 110 I do understand the output would be lower but actually don't need that much heat in that room anyway Thanks Gene

Hi all.. New to the forum.. Thanks in advance for any help.. I am trying to set up new baseboard heating in my basement.. My questions are to what size breakers to use and if I can put it all on one circuit.. I want to set up 3 rooms: Room 1 - 2 1000 watt heaters Room 2 & 3 - 1 1500 watt...

I've roughed in wiring to install 2 baseboard heaters in a room in my basement.I want to make sure that I got it right.I ran 12/2 wire from the panel to the wall thermostat box,then a separate 12/2 line out to each heater location.I want to use one 1000w heater and one 1500w heater and put them on...

Hello - I am putting in a ceramic tile floor in a bathroom and plan on cutting the tiles and using them for a baseboard. Is there a correct size that this baseboard should be? And should I put anything on the top edge of the tile to finish it off? Any information would be appreciated. Thanks!