Ask Experts Questions for FREE Help !
Ask
    legalbird's Avatar
    legalbird Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 19, 2007, 06:39 PM
    50A50-110 Control Board
    I have a 1995 ComfortMaker, forced air, NG, 80% efficient, furnace with a 50A50-110 control board. The original board was replaced in year 3 under warranty. I am now having regular problems with the furnace going out. The trouble light on the control board blinks from one to six at varying times indicating different problems, the usual display is for an open or closed low pressure switch. If I turn the unit off at the circuit switch and wait, I can often get the unit back on. I've had the various swithches checked and even replaced the low pressure sensor and switch to no avail. Interestingly, if I torque the wire harness connecting into the control board the problem seems to go away. Now I have wedged the wire harness and have not had a failure for over two weeks. I do fear that this will not last. The connections have been cleaned on the harness and the pegs of the control board. If I remove the wedge or jerk the connection the problem recurs. The replacement board would be a 50A55-843. Does it sound like I need a new control board?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jan 21, 2007, 07:53 PM
    Could be a defective connector or a crack in the board at the connector. Without being there it is impossible to tell.
    rickdb1's Avatar
    rickdb1 Posts: 185, Reputation: 15
    Junior Member
     
    #3

    Jan 22, 2007, 10:01 AM
    Unless you are comfortable with soldering connections, then I would replace the board as you have certainly determined the problem...

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bad Furnace Control Board? [ 6 Answers ]

I have a Carrier 58PAV that intermittently aborts or sometimes clicks on and off at the draft blower stage. I found out I can move the control board (HK42FZ007) when the blower motor clicks off, and it clicks and comes right back on. If I hold it just right, the furnace starts and if I manage to...

Furnace control board [ 2 Answers ]

Can the board be repaired or do I need to replace it

Power to furnace control board but stops there [ 3 Answers ]

Hi I was given a Nordyne KG6RA gas furnace. After installing, I turned on and there was a low hum when the power got to it. I held the door switch closed so I could see. After a few seconds there was a spark and then blue smoke and everything went dead. I could not see where the smoke came...

Wiring question for new blower control board [ 1 Answers ]

Just bought the Lennox blower control board replacement kit - 31M73 I'm stuck on wiring the transformer--- The five wires coming out of the transformer going to the old board are - Yellow - common Blue - 24 vac Orange-L2 XFMER Primary Black - L1 XFMER Primary Red - PARK

Powering the G terminal on my furnace control board [ 1 Answers ]

Hi! My furnace's control board recently blew and the repair guy replaced it with a different kind. Aparently the new board requires a wire from the thermostat to the G terminal to work the A/C fan, and the old one didn't. The repair guy would need to make another trip for this repair. I am...


View more questions Search