Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Cutting off metal ring around toilet flange
[ 3 Answers ]
As you can see from the attached picture, I'm trying to remove/cut off the metal flange that the bolts fit into that holds the toilet in place. Needless to say it had leaked and was rusted. What can I use to cut the metal ring off and how do I get under the plastic piece w/o cutting into it. ...
Cutting metal roofing.
[ 6 Answers ]
I have some old metal roofing that I want to recycle, however I need to cut it to fit my project. What is the best and easiest way to cut this ? Thanks
Ryobi 14" metal cutting saw, brushes?
[ 11 Answers ]
Hi, I have a Ryobi 14" metal cutting saw that seems to have lost power. When looking in the end of the motor as it works, the green sparking seems to be more than usual? Is this most likely the brushes? Is changing brushes a complicated job? Thanks in advance.
Cutting galvanised pipe with a metal blade saw.
[ 16 Answers ]
Can I cut a 3" galvanized pipe with a metal blade saw ? I am trying to replace a piece of drain pipe located in the bsmt ceiling with abs pipe. There is about 2'' space between the ceiling and the pipe, and I will have to cut above my head. Renting a special cutter is an option but expensive as...
Sparks from cutting metal dangerous?
[ 4 Answers ]
I have a metal bar that is used with a key as a shut-off for a gas line that goes into my fireplace. The bar sticks up from the floor about an inch. It is a tripping hazard for my daughter who walks near that area often. If I cut it off to the floor level, will the sparks created be any hazard... View more questions Search
|