Ask Experts Questions for FREE Help !
Ask
    lepojr's Avatar
    lepojr Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 24, 2008, 11:51 AM
    Wire size for a sub-panel?
    I have a 100 AMP main Service panel in my residence and plan on doing some kitchen remodeling. What size breaker would normally be used in a 100 AMP Panel to feed a sub-panel. Additionally, what size wire would feed the sub-panel from this breaker. I am think a 50 AMP breaker and # 8 wire to feed. Correct? Thanks, Pag
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
     
    #2

    Jun 24, 2008, 02:33 PM
    If you plan to use NM cable then your will need #6 for 50 or 60 amps. #8NM cable is only good to 40A.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wire Size and panel size [ 6 Answers ]

I have a separate small living quarters that is a single room that is about 180 feet away from the main panel. It is going to get another little bed room a small kitchen and a bathroom also maybe a washer. The main panel is a 100 amp meter socket combo. What should I upsize the main panel to? ...

Identifying this wire size in my breaker panel? [ 5 Answers ]

The wire running to the main breaker in my panel has the following written on the side of the wire. I am trying to figure out what gauge it is. The wire says, "GENERAL CABLE 3 TYPE THW 600V MTW GUARDIANT 090 3 MACHINE TOOL WIRE OIL RESISTANT 60 C" Thanks ahead of time.

Wire size for sub panel [ 1 Answers ]

Hi, :) We are converting a garage into a guest house, with permits, and I have a few questions on the electrical side. I have tried to search for my questions, but need more info. Plans are to place a 100 amp sub-panel 250 feet from main panel. Will # 2 in 2 inch conduit be enough, how much...

125 amp sub panel 250' away wire size [ 5 Answers ]

I have a 400 amp service in my home and will be running a line to my shop with a total run of 250' to feed a sub panel 125 amp service. What wire size is the 250' run? Would a 100 amp service be the same wire size? I would like to run copper wire, is aluminum that much less expensive? Any other...

100 amp sub panel wire size [ 2 Answers ]

I now have the 100 amp breaker installed in my load panel. I will run wiring from the load panel to a 100 amp sub-panel in an unground 80 schedule PVC. I believe I need to use #2 wire for the hots and the neutral. If this is correct, then what size ground do I use? Number 6? The sub- panel...


View more questions Search