Check out some similar questions!
Can Nashua 324 Tape be use on the INSIDE of metal duct at furnace out take? [ 9 Answers ]
I've used nashua 324A tape to seal up the custom metal duct I had to create to connect up my furnace to the existing heating duct. I used it on the inside and outside and was wondering if I'm at risk of a possible fire. The tape is rated to 325 degrees but I just wanted get some confirmation...
Main pipe covered with duct tape [ 2 Answers ]
The main plumbing pipe leaving my house has a joint where it goes off and over (sort of like a curved T valve) but the end is covered with duct tape. This is not the clean out valve but it is near this joint. We recently finished out our unfinished basement had a bathroom installed in the next to...
Basement ceiling exposed duct, pipes and wires [ 1 Answers ]
My basement ceiling to floor measue 72" from floor to drywalled ceiling. My problem the prior owners attached ductwork and wires over the drywall. A suspended ceiling will not work takes up to much height. Walls and floor concrete. Any suggestions would be helpful. If I could see some...
Residue from duct tape on ceramic tile [ 3 Answers ]
We used some duct tape to hold the tiles in place on a vertical surface, now we need to clean the residue without scratching the glazed surface. I tried using acetone nail polish remover, but it dries too rapidly. Any suggestions?
Safe to patch wtih electrical tape? [ 2 Answers ]
We had a mouse underneath our kitchen sink who ate through one side of the wire from the dishwasher power line. The wire is exposed, but again just one of them. I've unplugged the dishwasher for now. To pull out the dishwasher and replace the whole power line would be a big undertaking. Is it...
View more Electrical & Lighting questions Search