[uemjg]

I bought a new Hampton Bay celing fan w/a built it light kit and remote. After installing it the lights work fine, but the fan only works on the low speed. Is there a master speed setting in the fan that needs to be set on High? There are no pull chanins.

Thanks.

[ceilingfanrepair]

Not if there are no pullchains. Take it back. Are you sure you are switching speeds properly on the remote?

[uemjg]

Well what I tried to do to verify it wasn't the fan I did the following:

1. disconnected the wireless device and used a 2 slider fan/lamp manual controller. The lights worked fine but the fan only worked in the medium position, but it really didn't seem that fast.

2. I tried a dual single pole dimmer and either the lights work or the fan works.

*at least I know that the fan works on full speed and the lights do work.

Suggestions?

[ceilingfanrepair]

The fan has no pullchains yet you were able to use it without the remote receiver?

Still sounds like a bad receiver.

[uemjg]

The fan has no pullchains yet you were able to use it without the remote receiver?

Still sounds like a bad receiver.

I finally wired it correctly, but I also found out I had a bad manual switch. The wireless setup is straight forward wiring but the fan only ran in the low speed.

Currently I have a manual switch and both the lights and fan are working correctly.

THANKS!

[ceilingfanrepair]

I'm not sure what you mean by manual switch.. . But I'm glad you got it working.