Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Wiring single pole thermostat in double pole fixture
[ 3 Answers ]
Hello, I am trying to install a line voltage programmable thermostat into a manual thermostat fixture. The programmable thermostat is Honeywell RLV430. Instruction manual here: http://www.homedepot.ca/wcsstore/HomeDepotCanada/images/catalog/b7867367-6c05-4c82-a97c-648044b91564.pdf The...
20amp QUAD double pole versus 2 20AMP tandem single pole
[ 2 Answers ]
I have 5 zones of baseboard heat, 3 of which were disabled due to the addition of a heat pump. The circuit panel is full and would like to restore the operation of the 3 zones of base boardheat. I was planning on removing 3 double pole 20amp 240 volt circuits and installing 3 QUAD 20 amp double...
Double pole or single pole thermostat for baseboard heater
[ 2 Answers ]
A more specific question here: My 240v baseboard heater says it can be wired with a single or double pole thermostat. Since 240v is already "dual pole" with two hots, do I want to stick with a double pole thermostat? Are there advantages/disadvantages to each? Thanks.
One pole of untied double-pole circuit breaker breaks
[ 5 Answers ]
I recently purchased a new dryer (220 v appliance) to replace an older model. The old dryer was connected to the panel via a double-pole breaker except that there was no clip or tie between the poles. I changed the location of the outlet when installing the new dryer, replacing the cable with the...
Trying to change a single pole light switch to a single pole swith with a light below
[ 5 Answers ]
I have a kitchen light and a basement light that are together in one electrical box, but are on single switches. I purchased a "single pole switch and pilot light" combination so I could see easily if the basement light is on. In the box there is a black, red and white wire. For the single pole... View more questions Search
|