Search:
Type: Posts; User: kman1
Search:
Search took 0.00 seconds.
-
He is licenced and is pulling a permit for the job.
-
The electrician was first on that told me he wanted to use aluminum wire and could do the whole run without a splice. I asked him how he could do that and he said he would use "Se" wire. He hasn't...
-
I talked with one of the inspectors in my area and he tells me I can use SER Aluminum for the entire run without having to splice in the middle. He said I can do this because it will be fused since...
-
Just out of curiosity, what type of welding are you going to be doing? I do a lot of racecar fabrication in my home shop and have Oxy/Act, Stick, Mig, Tig and Spot welders here.
-
The receptical is a NEMA 50 type. It's rated for 50amps 250volts. What you are seeing is the rating on the plug not anything labeling the pins. The round pin is a ground and the other two are the...
-
It's a bit of a weird run from the main panel in the house. It goes down from the main panel a couple of feet, then snakes through some block to the basement. Then across the ceiling around a steel...
-
Can someone help me out if I am not wording my question correctly? Thanks, Kevin
-
Not an electrician but I do know something about welders. Most welders use a 3 wire connection since they do not use 120 volts internally. 2 hots and a ground. Your welder probably comes with a...
-
What is the proper term for when you are working on a circuit that has the breaker turned off and you still get shocked. Is that called backfeeding a circuit? I was trying to do a search for...
-
By cables I meant the wire types you recommended. Can either of them be used in my application for the whole run or do I have to buy two different types and splice them together when I change from...
-
Thanks for the answer but can I run either of these cables the both inside without conduit and outside with conduit for the entire run or do I have to use two different cables?
-
I have a detached garage I want to run a 100amp subpanel. The total wire length from main to subpanel should be less than 90ft(garage is about 50 ft away from house). I have to run from the main...
|