AC motor, three wires coming out. 1 Red, 1 Black, 1 White. How do I hook them up?
AC motor, three wires coming out. 1 Red, 1 Black, 1 White. How do I hook them up?
Hook them up to what?
AC motor, three wires coming out. 1 Red, 1 Black, 1 White. How do I hook them up to electricity to make the motor run?
What does the motor plate say about voltage
?
I know I look like a jerk, but do you really think this is enough information to give you any sort of accurate answer?
This is the best I can do under the circumstances: Motor Connection Diagrams
I have the same question... the motor is out of a toy rc car and I want too hook up a esc but there are 3 leads coming out of the motor red white.. and black (note the black wire is smaller than the other two,almost looks like a ground)while the esc hase only two wires for the motor?without pulling the motor how can it be hooked up/ do I just leave the black wire?
There is a ton of RC information on the web. Sites like Tower Hobbies and others, plus YouTube are very helpful.
Here is a three part series on motors and ESCs: RC Motor and ESC Wiring - Part 1 - YouTube
As good as the vid was it still doesn't help... I need to know what to do with the black wire,as I do not want to get a new esc and I don't want to open the rear drive train up and get a new motor... there must be a way I can do this/
:(
I know my way around and RC car pretty good, but unfortunately I can offer no help with this. Maybe someone else here is familiar.
Best I can suggest is to post this to an RC/hobby message board. This is a "Home & Garden > Electrical & Lighting" message board. Your situation does not at all relate.
All times are GMT -7. The time now is 10:40 AM. |