Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Help with wiring a HUNTER Ceiling Fan and Light Control
[ 16 Answers ]
I am currently replacing a light switch with a ceiling fan and light control. The description of what I am replacing with is: http://www.littmanbros.com/pd_hunter_27182.cfm I currently have a ceiling fan with a light kit (and it too high off the ground to have the fan controlled by a pull...
How to mount a wall mount pot filler
[ 3 Answers ]
I was thinking about installing a wall mounted pot filler in our kitchen. What type of fitting and mounting does this require. I am using ½” copper to a thread male. I will secure the pipe to the stud. Is this correct. How far out does the thread need to stick out of the wall.
Plug In Light Control Noma Model SE 12
[ 5 Answers ]
I have lost the instructions on how to set this gadget. Does anyone have the instructions? The control was purchased at Canadian Tire.
Wiring for DUAL wall switch to control Ceiling Fan and Light Separately
[ 20 Answers ]
Greetings. I recently bought a new ceiling fan and light kit to replace one that had been in my sun porch for over 20 years. A dual wall switch was always used to control the light and fan separately on the older fan. The fan speeds were controlled by pull chain. Before I took the old fan down, I...
Ceiling Fan/Light Dual wall control issue (I think)
[ 4 Answers ]
I tried to change the dual control switch on my ceiling fan with light to one that had a remote transmitter that was installed in the ceiling... I could not get it to work; so, I just replaced it as it had been. (Or so I thought!) Now, the light works but the fan does not. I must have done... View more questions Search
|