Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Wall Heater Problem
[ 7 Answers ]
My home is heated by an older model Empire wall heater. The heater did not start up last week and I could not figure out the problem so I called a repair man. He found a wire in the heater that had become disconnected and hooked it back up, after which he was able to start the heater by lighting...
Gas water heater & gas dryer
[ 4 Answers ]
I just moved into an duplex and purchased a gas dryer in excellent condition from a local thrift store. My trouble is, I don't see anywhere to hook the gas line (from the dryer up). It looks like there is just an electrical outlet. Can someone help? Isn't there some kind of two prong gas line...
GFCI for wall heater?
[ 2 Answers ]
I'm installing a wall heater in a small bathroom. The heater will be next to a pedestal sink and controlled by a wall switch. The heater will be on its own 12 gauge, 20 amp circuit. The question is, should I install a GFCI outlet in the line before the heater to give ground fault protection to...
240 Volt Wall Heater
[ 7 Answers ]
I have hooked both wires to separate circuit breakers one white and one black and connected them to the black and red leads from the wall unit and the ground poles on the heater box but it does not work. If I disconnect the white wire from the circuit breaker and connect it to the white posts on...
240 volt wall heater
[ 3 Answers ]
I am installing a wall heater in a room. The heater has a ground wire and a black and red wire. How do you hook it up to 240 volts? Do I need to run four wires, three wires? I have a double breaker at 20 amps already in the circuit breaker panel but what do I need to hook up power. Does one of... View more questions Search
|