I have a 3 way light and want to replace one of the light switch with a 3 way light motion sensor swith. Ky sensor has a red black brown and green cable. By light switch has 2 black and 2 red cable. How do I hook this up? Thanks for your help
Add your answer here.
Check out some similar questions!
Wiring Leviton 3 way motion sensor switches [ 17 Answers ]
Have done a search and found another post with the same question, but no info on the reslution of the problem. I put in a stairwell to the basement with a landing and 90 deg turn. I have installed a light fixture above the landing to light the stair well and want to control it with motion...
3way switches and motion sensor combination wireing [ 3 Answers ]
I would like to know how to wire up two 3way switches and motion sensor combined. Sequence of operation is as follows; when you walk in room motion sensor detects motion turns the lights on but you can also control the same flouresant lights by using the 3way toggle swithes so you basically have...
2 dimmer switches on 1 occupancy sensor [ 1 Answers ]
Just a basic question. Is it possible to connect 2 dimmable switches to one occupancy sensor (in a 3 gang box) so I can save money and box size? Thank you
Disable a Motion Sensor on 3way Switches [ 2 Answers ]
I'm ready to "throw in the towel" on my outdoor floodlight, motion sensor operated by three-way switches. Most of the time the driveway just stays in the dark because the two different motion sensors I've tried are complicated to figure out on a 3-way switch. So I simply want to by-pass the...
Wiring 3 way motion sensor switches [ 1 Answers ]
Hello! I have 2 3-way motion sensor switches I want to install in my garage. There currently are two 3-way switches on different walls. The setup is different from another thread I was reading on this site.. . In my case the power (2 wire w/ground) goes to the light, and each of the switches...
View more questions Search