Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Romex in PVC Conduit ?
[ 26 Answers ]
Need to run #12 wire to my gate opener. Have 1" schedule 80 conduit in ground. Can I run 12/2 Romex through the conduit to feed the gate ? Or do I have to run individual wires. Thank You
I have romex installed in a conduit for about an 8ft run. Is this OK?
[ 2 Answers ]
I upgraded my garage to add a couple of receptacles. The bulk of the wire is running through the rafters of my basement, but I enclosed about the last 8-10ft of romex NM-2 in 1" PVC conduit for mainly protection since this was going to be exposed. Now I have some concerns after reading that I...
12/2 NM-B Romex in PVC Conduit
[ 4 Answers ]
Hi. I need to bring 2 new circuits from the panel in the garage to the basement. I would like to use 12/2 NM-B (Romex with ground) from the panel through PVC conduit to the basement. It is about a 12' run, then a 90 degree turn, then about another 10' to a spot below the panel. At this point it...
Romex in conduit
[ 3 Answers ]
I have 1/2" rigid conduit, can I run 12 AWG through it for a length of about 6'? It will be a single cable pull, and it has one 90 degree bend.
Can romex be installed in a conduit
[ 13 Answers ]
I am installing a new 100A sub-panel. The feed will be from main with a 100A dual-pole breaker. The main and the sub-panel are in the basement. The new sub-pnael Will be about 25 feet from main. I already bought the feed cable for this sub-panel. I bought #4/3 With Ground NM-B romex. The... View more questions Search
|