Ask Experts Questions for FREE Help !
Ask
    jidoh7's Avatar
    jidoh7 Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 13, 2007, 07:33 AM
    277V lighting switch installation
    I want to replace a three-way switching configuration for a 277v circuit with a single-switch configuration. The current configuration has gray and brown wires in addition to the orange wires, which I assume are the travelers. How do I wire up the one-way switches?
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
     
    #2

    Oct 13, 2007, 12:24 PM
    Can you go to other switch to be removed, remove one Traveller wire, cap off then twist other 2 together?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Installation of pendant lighting [ 1 Answers ]

I am trying to install a pendant light and have lost the instructions. Can anyone give me advice as to where to get instructions or how it may be installed? :rolleyes: Help! Jane

Need to add 3-way lighting to a single pole switch [ 1 Answers ]

Hello, I have some kitchen lights on a single pole switch. I want to add another switch to control the kitchen lights. I have power in a switch box that I want to add the 3-way light switch. I know Leviton and Lutron both make switches that can make this happen with out running a 14/3 wire between...

277v wiring [ 2 Answers ]

When wiring lighting or other devices on a 277v system, what colors go to what phase, in what order? I know the colors, but was asked on a test for employment this question, and I can't figure it out on a 3 phase system.

24 volt lighting switch covers [ 1 Answers ]

I just bought a house built in 1957 that has 24 volt lighting controls. The wall switches have rocker / push buttons that switch relays in a control panel to turn on / off the 120 volt overhead lights. Local electrical contractors tell me the system is obsolete and I cannot find parts. Right...

X-10 Lighting With A 4 Way Switch [ 2 Answers ]

I have an X10 dimmer module that I just got. I am currently replacing a 4 way switch. The current 4 way switch has 4 total wires. 2 wires go into the input and the other 2 go into the output. The X-10 module has 3 wires. How do I know where the 4 wires to the X-10 module go? The new X-10 module has...


View more questions Search