Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Generator transfer switch - enough for well pump
[ 1 Answers ]
I have a 10hp 5600 generator that I want to connect to a "GenTran 20216 Manual Transfer Switch". It states that this transfer switch has 6 switches (rated 15 amps ea), a handle tie for one 2-pole circuit such as a well pump. My question is this - my well pump is 220 30 amps. Does two switches at...
Portable Generator to House Connection
[ 5 Answers ]
Hello, Could I get a explanation on the below statement I read on another post. "When using the generator powering the house, the neutral to ground bond in the generator should be removed. When independently operating the generator, it should be present.
240v vs 120v well pump
[ 1 Answers ]
Hello guys I would like to know which is better . I have a electric well pump that can either be wired 240v or 120v but I don't know which would be more efficient. Could some one please give me some advice.:confused:
Adding a small heater to a 240v irrigation pump
[ 2 Answers ]
I have a 3 HP irrigation pump fed by a normal 240v service line from a relay activated by the irrigation controller. The pump uses 2 lines plus a ground. I have one extra conductor line running to the pump station. Is there a code acceptable way to use that line, and one of the pump lines to...
Confused with Electrical Connection to my new Steam Generator
[ 1 Answers ]
Hello, I just purchased a new replacement Steam Generator for my Master Shower. It is installed in the attic about 40' from main service panel. Unfortunately, I didn't pay attention to the electrical connections on the old Steam unit and simply untied all wires and removed the old unit. I didn't... View more questions Search
|