 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Silicone between a 2 piece shower unit?
Hello, We have a 2 piece shower unit with a gap between the wall and the tub. Should I use silicone to fill this gap? The gap is 1/16 to 3/16 of an inch and water goes in and lays in the back of it. We have trouble cleaning this gap. I have not used silicone because I am afraid mold or mildew will get in this or in the silicone.
Thanks. |
||||
|
||||
|
I'm guessing this is a fiberglass tub and wall unit? You really don't have to caulk that at all if it is a fiberglass unit. There is usually a nailing flange on the top edge of the tub unit about an inch high. Then the wall unit rest down on top of the tub unit flange to prevent water from getting behind the tub unit piece.
You can use a mildew resistant latex/silcone based caulking for tub/tile application that will work if your worried about the gap. Clean and dry out the gap and then apply the caulking. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I am in the process of installing a bathroom in my new garage addition, and am seeking input for the 36" Sterling shower enclosure. 1) Instruction state that back and side walls can be attached to bare studs or over water resistant wall board. Any opinions on which is best? 2) The base I plan to...
"Do they make a drain receptor with female threads on the inside that could be glued to the 2" pipe afer the base is set, and with the drain grate screwing into that?" They do but I'm not too sure you can use it on a manufactured shower base. It's called a "flange type shower drain", (see image)...
I have a one piece shower that is leaking. I have taken the quarter round off around the front of the shower unit and the adjacent base boards and water is slowly seeping out from under the shower. The quarter round trim was very wet. Is there anyway to get the remaining water out from under the...
We have a bathroom in the basement which has a tile shower. The shower started leaking and rotted away the wood around it, so I removed the shower completely (all you see are the studs on the wall and the drain pipe in the ground). It used to be a 36" shower stall, but there is additional space...
I am desiging our new home and want to verify that 2 tub-shower units can be installed in two symmetrical adjacent bathrooms with the drains facing a common water wall. This will be slab on grade construction. The bathrooms will be std 5' x 12' with the tub-shower units installed against the back...
View more questions Search
|
