Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Installing a french door in concrete block
[ 3 Answers ]
I’m thinking about installing a new French door in by basement. My question is what is the best way to attaché to the door to the concrete block? Should I cut the opening to the required rough opening size and attach the door directly to the block. Or should I make the opening larger, and frame the...
Installing garage door to clear lift
[ 2 Answers ]
I plan to build a garage with a lift in it. I would like to be able to open and close the door with the lift raised but this would mean the garage door tracks would have to follow the rafters (rafter tails sit above garage door) so the door would not hit the lift when it is raised. If I modify the...
Installing a new door in a load bearing wall
[ 4 Answers ]
I need to install a door in a load bearing concrete block wall between my garage and utility room. What should be the length, width, and thickness of the lintel plate I install over the rough opening?
What is the cable/wire gauge (product name) for installing 200 Amp Service Entrance
[ 1 Answers ]
I am installing a new service entrance to upgrade my home electrical service to 200 amps. 1 Please tell me what gage wire is required from the meter to the weather-head? The service panel with main breaker is inside the laundry room 25 feet from the outdoor meter loop. I will run the...
Will installing a door interfere w/hvac?
[ 1 Answers ]
I have a hallway that connects two bedrooms and a bath. The hall is 3’ X 10’ and the entrance to the hallway from the living area is about 2’ from one end. As you enter the hall, the thermostat is on the opposite wall and the cold air return (only one in the house) is in the ceiling slightly to... View more questions Search
|