Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Attaching new 2" drain pipe to existing 3" soil stack - PVC
[ 4 Answers ]
All, I am installing an additional sink on the main level of my home. On the lower level, below, there is a main 3" soil stack. I am thinking to use a 3"x2" Y connector to tie 2" drain pipe into this main soil stack. The sink will be vented using AAV (island) Questions: 1. Is there any...
Teflon or Pipe Dope for 1 1/4" Water Pipe
[ 7 Answers ]
I am building a project that uses several joints of 1 1/4 " galvanized pipe, including elbows and Tee's. The unit will be plumbed into my 50 psi water system. What is the best way to seal the pipe joints? I have assembled the unit and tested using teflon pipe dope and had several leaks.
Adding a PVC "Y" to a underground Cast iron pipe
[ 1 Answers ]
I have a house built in 1962. The cast iron waste pipe runs under the concrete slab in the basement. I have already dug and confirmed the location I want to cut a section out of the pipe and install a "Y" connector and run new plastic waste pipes to a new bath. I have seen PVC connectors that...
Broken Concrete trap "Drainage Pipe"
[ 1 Answers ]
I recently bought a house with a unfinished basement bath. I have since decided to finish the bathroom but have ran into a bit of a problem. The previous owners set all of the drains up and I have since found a large hole in the trap of a secondary drain that drains into the main. To explain it...
Tub to Shower 1.5" pipe to 2"pipe
[ 6 Answers ]
Shower uses a 2" pipe. Tub used a 1.5 inch pipe. Bought a 2"pipe coupler... using the coupler to attach the new 2" pipe to the old 1.5 inch joint on the 3" main house drain pipe. The coupler has too much play on the 1.5 inch side... almost like it's an 1/8th of a inch smaller than 1.5. What's... View more questions Search
|