Ask Experts Questions for FREE Help !
Ask
    drysmoke's Avatar
    drysmoke Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 27, 2009, 10:40 PM
    Ford 6.0 Turbo Diesel trouble
    I have a 2003 6.0 turbo diesel which will not run right till it warms up
    It also acts like it is vapor locking at times when you start and then try to leave even on hot days.
    This is a problem I can not figure out
    New fuel filters new air filter and even with fuel additives it still runs awful till it warms to operating temp.
    I could use some experienced help on this one.
    I have been told to change the cam sensor but before I do that I wanted to ask first if some one knew what the problem was.
    Thanks
    mpolo's Avatar
    mpolo Posts: 117, Reputation: -3
    Junior Member
    		  
    #2

    Aug 28, 2009, 01:06 AM

    Yes you should take to a Ford Dealership and change the cam sensor.
    itsjb5's Avatar
    itsjb5 Posts: 39, Reputation: 1
    Junior Member
    		  
    #3

    Aug 29, 2009, 08:30 PM

    Recall on sensor?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ford F350 7.3 PS Turbo Diesel Cold Weather Starting Issues [ 14 Answers ]

I bought this wonderful 1995 Ford F350 Crew Cab 7.3 PS Diesel truck this summer and as of lately (now that the temps are dropping below 45) I am having one heck of a time starting it. In fact, temps were 26 degrees a couple of mornings ago and it took no-kidding nearly 20 minutes of fooling around...

2003 Ford 7.3 Power Stroke Turbo- Diesel [ 5 Answers ]

I have a 2003 7.3 power stroke turbo-diesel runs great however after driving the vehicle 5 to 15 minutes starts to bogg down looses all power as if, starving for fuel If let sit for 20 minutes will start up and run for another 15 minutes and stop again.Changed the fuel pump and have a full tank of...

1996 ford turbo diesel 7.3 L [ 1 Answers ]

It takes about 4 start cycles to start the engine in the morning. After that it will start right away. Outside air temp is 50 degrees F. Any ideas?

View more questions Search