Ask Experts Questions for FREE Help !
Ask
    PhilJ's Avatar
    PhilJ Posts: 3, Reputation: 1
    New Member
     
    #1

    Jul 12, 2005, 03:44 AM
    How do I display ECU codes on a 1993 Civic (5th gen)?
    Can't seem to find that info on the net, only up to 91 (4th gen).

    Thanks,
    Phil
    TimH's Avatar
    TimH Posts: 4, Reputation: 1
    New Member
     
    #2

    Jul 19, 2005, 05:23 AM
    No-Start on '94 Civic DX
    I have the same problem as PhilJ, I can't find any info on how to display the error codes for a '94 Civic. I have read the FAQ posted by CroCivic91 but my Civic has different color wiring. Tried jumping similar looking plugs but to no avail yet.
    The engine turns but won't start. It was left in the hot sun for three weeks straight and won't start now, never had a problem before but always parked in a garage. I know the main relay can cause a no-start when the cabin temps get high so I just wanted to check the error codes before I go replacing parts. Any help would be greatly appreciated. Thanks.
    -Tim
    PhilJ's Avatar
    PhilJ Posts: 3, Reputation: 1
    New Member
     
    #3

    Jul 19, 2005, 05:29 AM
    Ok, I found out, on my girlfriends car it is not gray, it is blue. See that green rubber cover that contains TWO plugs right above your ECU? Remove the one with TWO wires in it. Jump those two wires with a scrap of wire across the pins or a paper clip or whatever. Then turn the key to on, and the check engine light will flash to show the codes.


    For your problem, pop the main relay out (next to the fuse panel held on with one bolt with a 10mm head). Then open the case on the relay and re-solder the cracked joint(s) and put it back together. Free fix if you have a soldering iron. If you don't, a $10 soldering iron will do the job, and then you will have one cheaper than a relay.


    HTH,
    Phil
    TimH's Avatar
    TimH Posts: 4, Reputation: 1
    New Member
     
    #4

    Jul 19, 2005, 07:15 AM
    Thanks man. I'll try that as soon as I get home. I already own a soldering gun so hopefully it'll be a very cheap fix. Thanks again.
    -Tim
    PhilJ's Avatar
    PhilJ Posts: 3, Reputation: 1
    New Member
     
    #5

    Jul 19, 2005, 07:18 AM
    Glad I could help.
    Here is a nice link on soldering the main relay if you need it:
    http://www.markl.f9.co.uk/howto/elec...main-relay.htm

    Phil
    TimH's Avatar
    TimH Posts: 4, Reputation: 1
    New Member
     
    #6

    Jul 20, 2005, 04:25 AM
    CEL doesn't flash
    I jumped the plug last night and my CEL comes on but just stays on solid, never blinks or does anything. The only light that flashes is my SRS light and that just flashes continuously, no repeating pattern or pauses and I watched for quite awhile. Anyone ever have this problem too? I'm going to resolder the main relay just in case but am confused about the CEL remaining continuously lit.
    honda6119's Avatar
    honda6119 Posts: 4, Reputation: 1
    New Member
     
    #7

    Nov 25, 2005, 01:35 PM
    TimH. Did you ever find out what causes your CEL light to remain on when jumping to diagnsotic connector. I am experiencing the same problem on my 1994 Civic EX. I put the jumper in, turn on the ignition, and the CEL remains on (no blinking) and the SRS light flashes continuously (no repeating pattern).

    Honda6119
    biglou75's Avatar
    biglou75 Posts: 2, Reputation: 1
    New Member
     
    #8

    Jan 3, 2006, 10:17 AM
    honda6119 have same problem with CEL when checking for codes. Can't get 92 si to start, resoldiered relay and tested good. Still no spark or fuel, hot wired fuel pump checks good, also checked ignition switch (o/k). Tested ICM, coil all o/k. still no starting yet turns over fine. Stumped.

    biglou75
    beltrajp's Avatar
    beltrajp Posts: 15, Reputation: 1
    New Member
     
    #9

    Feb 7, 2008, 06:24 AM
    I've got the same symptons.
    I use to see the error code using the blue connector, but now the Check Engine ligth remains on and the SRS light Blinks Continuosly.

    I think it should mean something.!

    Could anuy of you discover what's it mean?

    Tank You
    alexferrao's Avatar
    alexferrao Posts: 1, Reputation: 1
    New Member
     
    #10

    May 20, 2010, 08:26 PM
    Guess no blinks mean bad ecu
    erickstorer's Avatar
    erickstorer Posts: 1, Reputation: 1
    New Member
     
    #11

    Sep 7, 2012, 01:02 PM
    Mine flashes 3 fast 5 fast 7 fast... 3 and 5 are both map sensors, are there really 2 map sensors?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1993 Civic DX Won't Start.. . Need Help! [ 90 Answers ]

1993 Honda Civic DX--122,000 miles Symptoms Engine cranks but will not start. The “Check Engine Light” (MIL) stays on, along with the oil and battery lights. When the service check connector terminals were jumped, the MIL did not indicate any Diagnostic Trouble Codes. You hear the first...

1993 Civic Jumper Cables Crossed [ 6 Answers ]

We tried to Jump the car, but of course broke the golden rule, DON'T CROSS THE WIRES!! Now there is nothing happening after I have switched in a Brand New Battery. Are there some simple test I can do to check, or is it too late for anything?

1993 Honda Civic Alarm Shutdown [ 1 Answers ]

My brother bought a 1993 Honda Civic and his car won't start, because the alarm systems shut down. The sunroof doesn't open, and the car won't start. The system functions are stuck. What to do?

1993 civic [ 1 Answers ]

Starts up cold... runs then after gets warm it jerks down the street an shuts off,will start up again only if you turn the key on off repeatly with a pedal Idle OK,but when you accelerate it stalls(rpm needle race up an down)firestone checked the code an said it didn't read any... but they...

1993 Civic DX Won't Start [ 4 Answers ]

Even after reading all the postings on not starting, I still have my own! Here's where I'm at: - Started in the morning to go to work and it died after about 5 seconds of running - The engine continues to turn over freely, but does not run - The engine does get gas (as evident by smell and on...


View more questions Search