Ask Experts Questions for FREE Help!
  Advanced
Register  |  Log in  
   Ask    
 Answer  
  Help  

Ask QuestionsprogressAnswer QuestionsprogressBuild ReputationprogressBecome an Expert
 
Free Answers in 3 Easy Steps

Register Now
3 Steps

At Ask Me Help Desk you can ask questions in any topic and have them answered for free by our experts. To ask questions or participate in answering them you must register for a free account. By registering you will be able to:
  • Get free answers from experts in any of our 300+ topics.
  • Accept money for answers that you provide.
  • Communicate privately with other members (PM).
  • See fewer ads.

Home > Home & Garden > Cars & Trucks   »   ford taurus

 
Question Tools Search this Question Display Modes
Question
 
 
#1  
Old Jun 30, 2007, 09:39 PM
plabbe
New Member
plabbe is offline
 
Join Date: May 2007
Posts: 10
plabbe See this member's comment history on his/her Profile page.
ford taurus

I have a 1996 ford taurus not a bad car we had no major trouble until now .It ran out of gas and now I have to crank it many times before it finaly starts and it keeps on stalling for the first 20 to 25 start,everytime it starts it runs a little better for a few seconds then stalls again I keep on starting it until it will run very rough but runs on its own and keep on getting better just like if the pistons would kick in one at a time .From the time it stops stalling to the time it iddle normally it probably takes 3 to 5 minutes then iddles ver good rpm holds at 1000 no missing,shaking or no noise it works fine until I try to accelerate then I can bring the rpm to 2000 only for 1 second and it sounds like its running out of gas if I let go of accelerator it will pick right up to 1000 rpm ,if I dont let the accelerator go quick ennough it will stall.
I have new gas,gas filter,sark plugs,fuel pump and regelator test ok vaccuum line are ok but I still cant get it to start right away like before and still can use the accelerator.

I would really apreciate anyone idea or cure to my problems.
Thank you.

Reply With Quote
 
     

Answers
 
 
Old Jul 1, 2007, 06:07 AM   #2  
kitch428
Senior Member
kitch428 is offline
 
kitch428's Avatar
 
Join Date: Nov 2006
Location: East NC, y'all
Posts: 559
kitch428 See this member's comment history on his/her Profile page.
Sounds like you did in your fuel pump. Or, by running out of gas, the pick up strainer at the end of the pump could be clogged with sediment from the bottom of the tank. Either way, both need replace.
  Reply With Quote
 
     
 
 
Old Jul 1, 2007, 11:42 AM   #3  
txgreasemonkey
Cars & Trucks Expert
txgreasemonkey is offline
 
txgreasemonkey's Avatar
 
Join Date: Jun 2006
Location: Undisclosed, Republic of Texas
Posts: 4,761
txgreasemonkey See this member's comment history on his/her Profile page.txgreasemonkey See this member's comment history on his/her Profile page.txgreasemonkey See this member's comment history on his/her Profile page.txgreasemonkey See this member's comment history on his/her Profile page.
. Check for codes.

. Check for proper fuel flow and pressure. The fuel rail must be fully pressurized, in order for a fuel injected engine to start.

. Check Ignition Control Module and coil. AutoZone and O'Reilly Auto can do this for free.
  Reply With Quote
 
     
 
 
Old Jul 1, 2007, 05:15 PM   #4  
cjcdallas
Junior Member
cjcdallas is offline
 
Join Date: Feb 2007
Posts: 65
cjcdallas See this member's comment history on his/her Profile page.
You also have an in line fuel filter back by the fuel tank...You should replace that one as well...
  Reply With Quote
 
     
 
 
Old Aug 29, 2007, 12:09 PM   #5  
plabbe
New Member
plabbe is offline
 
Join Date: May 2007
Posts: 10
plabbe See this member's comment history on his/her Profile page.
thanks alot for your help guys I change the fuel pump.filter.the cam shaft position sensor cause I get the code p0340 and my car still wont start normaly and I cant get the rpm over 1500 if I push it very slowly I cant drive it like this and I dont know what else to change .
Any idea anyone ???Its a 96 ford taurus 3liter with 24 valves
Thanks in advance and I really enjoy this site.
  Reply With Quote
 
     


Question Tools Search this Question
Search this Question:

Advanced Search
Display Modes

 
Similar Sponsors

Similar Questions
Question Asker Topic Answers Last Post
1998 ford taurus toyaiz25 Cars & Trucks 1 Jun 10, 2007 11:50 AM
1999 Ford Taurus mjgg02 Cars & Trucks 1 Jan 16, 2007 12:04 PM
Starter on a Ford Taurus ChristineL Cars & Trucks 3 Jul 6, 2006 06:38 PM
91 ford Taurus tboyterry Cars & Trucks 3 Mar 5, 2006 08:12 PM
88 Ford Taurus Transmission Problem evaneric2 Cars & Trucks 2 Aug 2, 2004 05:35 AM




Copyright ©2003 - 2007, Ask Me Help Desk.
All times are GMT -8. The time now is 01:19 AM.

Content Relevant URLs by vBSEO 3.0.0 RC6 © 2006, Crawlability, Inc.