Ask Experts Questions for FREE Help !
Ask
    thesauce's Avatar
    thesauce Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 14, 2008, 10:58 AM
    Did Chevy make a C10 that is 4 wheel drive?
    I recently bought a 1978 Chevy C10 that is 4 wheel drive. I was told it was completely stock. I have since read that the C10's were all 2 wheel drive and the K10's were 4 wheel drive. What's the deal?

    Thanks!
    CaptainRich's Avatar
    CaptainRich Posts: 4,492, Reputation: 537
    Cars & Trucks Expert
     
    #2

    Jan 14, 2008, 04:08 PM
    It probably is stock.
    "C" was the designator for 2WD and "K" was for 4WD.
    But that didn't start till later.
    Early to mid-eighties, I think.
    owensRK's Avatar
    owensRK Posts: 3, Reputation: 2
    New Member
     
    #3

    Jan 17, 2008, 01:18 PM
    Pretty sure C stans pickup and K is for Blazer. Has nothing to do 2wd or 4wd

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1996 GMC / Chevy S10 Blazer Steering Wheel Removal [ 2 Answers ]

I need to remove the steering wheel on a 1996 GMC S10 Blazer with tilt. I am already familiar with disabling and removing the air bag, and removing the nut that holds the steering wheel to the column. Chevy has a special puller to remove the wheel. My question is, can I use a generic puller...

Shifting 4 wheel drive [ 1 Answers ]

I bought a 1994 pathfinder 4 wheel drive.. is there a trick going from 4 wheel high to 4 wheel low.. my shifter says 2w drive.. neutral.. 4 wheel high then 4 wheel low... it goes into 4 wheel drive fine.. I just can't seem to figure out how to go from high to low.. its a manual shft not electric.....

Chevy Blazer steering wheel removal [ 1 Answers ]

I would like to know how to remove the factory steering wheel with air bag. For the installation of an aftermarket wheel. Without airbag.

'97 chevy wheel hubs [ 2 Answers ]

'97 chevy cavalier. Getting a hum from the front end, and a growl when I turn. Anyone ever change the wheel bearings, are they one piece? Just curious as to what the job entails.

1954 chevy steering wheel and horn [ 1 Answers ]

Am trying to figure out the correct way to assemble the steering wheel and horn ring section on a 1954 chevy. I have a large steel (looks like a washer) and a clear plastic ring. Do these go in behind the steering wheel or under the orn ring between the horn ring and wheel? Can't find the answer...


View more questions Search